Unique Polymer Systems ‘Plastic Steel’
CHARACTERISTICS
Unique Polymer Systems -‘Plastic Steel’ is a high performance, rapid-curing, synthetic metal repair compound specifically developed for on site repairs to metal components such as castings, worn threads, jigs and mould patterns.
Unique Polymer Systems -‘Plastic Steel’ is based on a unique epoxy resin system co-reacted with anorgano-sulphur / amine blend which are then interspersed with specially chosen pigments and fillers which allow the base and activator components to be packed in intimate contact with each other.
APPLICATION
The reaction only occurs when the two components are hand mixed and the resultant blend produces a repair material with high physical and mechanical strength.
’Unique Polymer Systems -‘Plastic Steel’ also has the ability to set underwater which makes it highly suitable for submerged conditions.
Volume Capacity:
66 cc (4 cu. in) per unit.
PHYSICAL CONSTANTS
Mixing Ratio - Supplied ready to use
Appearance Concentric colored stick of putty consistency.
Drying & Cure times at 20°C (68°F)
Usable Life |
6 minutes |
Initial Set |
15 minutes |
Machining |
30 minutes |
Full Mechanical |
2 hours |
Volume Solids |
100% |
V.O.C |
Nil |
Shelf life
Use within 5 years of purchase. Store in original sealed containers at temperatures between 5°C (40°F) and 30°C (86°F).
Food Contact
Meets USDA requirements for incidental food contact.
Meets FDA requirements CFR 21.175.300 for food contact.
Operating Temperature
|
Maximum |
Continuous |
Dry Heat |
250°C (480°F) |
120°C (248°F) |
Wet Heat |
120°C (248°F) |
70°C (158°F) |
PHYSICAL PROPERTIES
Compressive Strength ADTM D695 |
350 kg per cm² (5000psi) |
Tensile Shear Adhesion ASTM D1002 (Grit Blasted Steel) |
45 kg per cm² (5000psi) |
Flexural Strength ASTM D790 |
230 kg per cm² (3250psi) |
Heat Distortion Temperature ASTM D648 |
40°C (96°F) |
Hardness (Shore D) ASTM D785 |
85 |
Corrosion Resistance ASTMB117 |
5000 hours |
HEALTH AND SAFETY
As long as normal good practice is observed Unique Polymer Systems ‘Plastic Steel’ can be safely used. Keep skin contact to a minimum. Use barrier cream or disposable gloves. Wash off areas of contact with soap and water. A fully detailed Material Safety Data Sheet is either included with the material or is available on request.
PACKAGING
Supplied in 0.125kg packs.